HelpCenter

365Dining/ReadyTouch - Ariva-S Mini Scale Setup
Updated

Purpose

The purpose of this document is to provide instructions for configuring an Ariva-S Mini Scale.

 

 

Process

Mini scales can be configured with either a COM to Serial or COM to USB connection. Whether the customer receives a COM to Serial or COM to USB depends on their preference (if any) when ordering.

The scale must also be properly configured in the Device Summary page of the associated kiosk in ADM.

 

Button functionality:

mceclip0.png

 

COM to Serial

  1. Power on the scale by plugging in the power cord.

  2. Once the scale is fully powered on press and hold the ->T<- button for 8 seconds. This will take the scale into user mode. The “CONF” prompt should show up on the display.
    conf.png

  3. Cycle through the options using the ->T<- button. Cycle until you see “GRP 3” on the display.
    mceclip1.png

  4. Select the “GRP 3” menu using the ->0<- button.
    • The display should now show "31 1".
      mceclip2.png

  5. Press the ->T<- button until you see the 1 change into a 0. If it's on a different number other than 1, cycle until you see the number 0.
    mceclip3.png

  6. Once the display shows “31 0” press the ->0<- button.

  7. Press the ->0<- button until you show GRP 4.

  8. Cycle the display using the ->T<- button until you see "EJlt". Press the ->0<- button.
    mceclip4.png

  9. The display will show a “SAVE” prompt. If it doesn’t, then cycle using the ->T< button until it does. Once the “SAVE” screen is displayed, press the ->0<- button.
    mceclip5.png

  10. The scale will reboot once it is saved and return to the original screen.

 

COM to USB

  1. Power on the scale by plugging in the power cord or ‘COM to USB’ cable (don’t plug in both).

  2. Once the scale is fully powered on press and hold the ->T<- button for 8 seconds. This will take the scale into user mode. The “CONF” prompt should show up on the display.
    mceclip1.png

  3. Cycle through the options using the ->T<- button. Cycle until you see “GRP 3” on the display.
    mceclip2.png

  4. Select the “GRP 3” menu using the ->0<- button.
    • The display should now show “31 0”.
      mceclip3.png

  5. Press the ->T<- button until you see the 0 change into a 1. If its on a different number other than 1 then cycle until you see the number 1.
    mceclip4.png

  6. Once the display shows “31 1” press the ->0<- button.

  7. The display will next show “36 3”. Press the ->0<- button again.
    mceclip5.png

  8. The display should now show “GRP 4”. Cycle using the ->T<- button until you see “EJIt”. Press the ->0<- button.
    mceclip6.png

  9. The display will show a “SAVE” prompt. If it doesn’t, then cycle using the ->T< button until it does. Once the “SAVE” screen is displayed, press the ->0<- button.
    mceclip7.png

  10. The scale will reboot once it is saved and return to the original screen.

 

ADM Settings

In the Device Summary page of the associated kiosk there is a field called Scale. Make sure to set this option to match the scale's cable configuration (Serial or USB).
scale_field.png