HelpCenter

PicoMarket International Assembly Instructions
Updated

Table of Contents

 

Tools Needed

  • #1 Phillips-head screwdriver
  • 1/8” hex driver
  • Antenna bolt tool

pm1.jpg

 

Hardware Bag Contents

  • Four (4) M3 x 5mm screws
  • One (1) plastic split wire loom

pm2.jpg

 

Process

Step 1

Remove the back cover of the stand by removing four screws with the hex driver.

pm3.PNG

 

Step 2

Remove the cover from the PicoMarket housing by removing the Phillips screw.

pm4.png

 

Step 3

Place the PicoMarket into the slot on the front of the stand.

pm5.png

 

Step 4

Install the four M3 screws to secure the PicoMarket to the stand.

pm6.png

 

Step 5

Plug the Molex power cable into the PicoMarket.

pm7.jpg

 

Step 6

Plug the Ethernet cable into the Ethernet port.

NOTE: Ensure you are plugging the Ethernet cable into the correct port. Failure to do so will result in a lack of network connectivity if you choose to use Ethernet.

pm8.PNG

 

Step 7

Use the antenna tool to screw in the mini coax antenna cable.

NOTE: At this point, you may wish to test the PicoMarket by plugging in the power cable to ensure all functionality before closing the cables up.
pm9.png

 

Step 8

Fit the wire loom over the cables.

pm10.jpg

 

Step 9

Reinstall the PicoMarket backplate and insert the Phillips screw.
pm11.PNG

 

Step 10

Ensure all cables are tucked inside the PicoMarket stand and reinstall stand backplate and screws.
pm12.PNG