Table of Contents
- #1 Phillips-head screwdriver
- 1/8” hex driver
- Antenna bolt tool
Hardware Bag Contents
- Four (4) M3 x 5mm screws
- One (1) plastic split wire loom
Remove the back cover of the stand by removing four screws with the hex driver.
Remove the cover from the PicoMarket housing by removing the Phillips screw.
Place the PicoMarket into the slot on the front of the stand.
Install the four M3 screws to secure the PicoMarket to the stand.
Plug the Molex power cable into the PicoMarket.
Plug the Ethernet cable into the Ethernet port.
NOTE: Ensure you are plugging the Ethernet cable into the correct port. Failure to do so will result in a lack of network connectivity if you choose to use Ethernet.
Use the antenna tool to screw in the mini coax antenna cable.
NOTE: At this point, you may wish to test the PicoMarket by plugging in the power cable to ensure all functionality before closing the cables up.
Fit the wire loom over the cables.
Reinstall the PicoMarket backplate and insert the Phillips screw.
Ensure all cables are tucked inside the PicoMarket stand and reinstall stand backplate and screws.