HelpCenter

Biometric Removal Instructions
Updated

Tools required

  • 9mm driver of socket 

  • Small crescent wrench

 Step 1.  Installed biometric reader. 

blobid0.jpg

Step 2.  Open kiosk door.  Remove four 9mm nuts and washers from the biometric reader mounting bracket.

blobid1.jpg

Step 3.  Remove bracket and biometric reader.  Save the nuts and washers.  These will be needed later.  

blobid2.jpg

blobid3.jpg

Step 4.  Grab cover plate and mounting hardware.  Kit includes cover plate and base mount hardware plate. 

blobid4.jpg

Step 5.  Install bottom base plate hardware using the washers and nuts previously removed. 

blobid5.jpg

Step 6.  Install the cover plate from the front of the kiosk.  Insert the screws on the cover plate through the mounting bracket base. 

blobid6.jpg

Step 7.  After the cover plate screws are inserted though the mounting bracket install the washers and screws on the two screw posts.  Tighten the screws firmly so the cover plate is flush on the front of the kiosk. 

blobid7.jpg

blobid8.jpg

Final step.. Contact Avanti support.  Have them disable the fingerprint reader from the kiosk record and send a full sync to the kiosk.  This will remove the consumer biometric payment prompts from the on screen user interface.