HelpCenter
  1. 365 Retail Markets
  2. Canteen
  3. iMonnit
Monnit - Canteen Deployment Procedures - External
Updated
Print
Scroll to Top
Table of Contents

Overview

The recommended Canteen Monnit temperature sensor self-install procedures are detailed below. The Phase 1 - Off-Site Planning iMonnit tasks (steps two through four) can be performed off-site if the location information, gateway, and sensor details are known. The Phase 2 - On-Site Setup includes the on-site software installation, physical hardware setup, and connectivity confirmation procedures.

 

Phase 1 – Off-Site Planning

  1. Canteen confirms with the site network administration that the Monnit network requirements are met. (Not required, but highly recommended – not applicable to sites with 365 VPN routers or OptConnect.) This information is available in the Network Requirements Guide.

  2. A location is created or confirmed as existing on the iMonnit website. This can be done by Canteen personnel (or 365 Support).
  3. A gateway device is associated with or confirmed as existing at the location in iMonnit. This can be done by Canteen personnel (or 365 Support).
  4. Sensors are associated with the gateway device and location in iMonnit. This can be done by Canteen personnel (or 365 Support).

 

Phase 2 – On-Site Setup

  1. Monnit software is installed or enabled on the local kiosk by Canteen personnel (or 365 Support).

    1. Legacy Platform – The software is installed from the kiosk operator account in Windows.
    2. V5 Platform – Monnit services are enabled in the POS.
  2. Canteen personnel attach the gateway to the kiosk. Sensors are situated and activated. These steps are explained in these external articles:
  3. Communication with the gateway and sensors are confirmed within iMonnit. This can be done by Canteen personnel (or 365 Support).